Pipe laying

Pipe laying for water, drainage and ducts

For getting water out to troughs and stables, draining a wet field or gateway, or running a duct for power to a building. A contractor digs the trench, lays the pipe to the right depth and fall, and backfills it, so you are left with water where you want it and a level field.

The work

What’s involved

Water supply pipe, usually blue polyethylene, is laid in a narrow trench deep enough to keep frost off, with joints and a stopcock where you need them and a connection to a trough at the end. On long runs across open ground some contractors pull the pipe in with a mole plough instead of an open trench.

Land drains are perforated pipe laid to an even fall, often bedded and covered in gravel, and led to a ditch or outfall. Getting the fall right is what makes a drain work, so the levels are set before the pipe goes in.

Ducts for electric or data cables go in with warning tape above them so anyone digging later finds the tape before the duct. The cable itself is pulled through and connected by an electrician.

When to do it

Dry ground in late spring to autumn makes for clean trenches, accurate falls and an easy reinstatement. Drainage is easiest to plan after a wet spell, when you have seen where the water sits.

Lay new water supplies before you need them: troughs fed in spring save carrying water all summer.

Pricing

What affects the price

  • The length of the run and the depth it needs.
  • What the pipe is for, and whether gravel, fittings, a trough connection or an outfall are part of the job.
  • Whether the contractor supplies the pipe or you have it already.
  • The ground: grass, a hard yard or a track to cross, rock or old drains in the way.
  • Reinstatement of turf or hard surfaces afterwards.

Good to know

  • Know where the water will come from before you ask: a tap, an existing pipe or the meter, and how far it is from where the water is needed.
  • A new connection to the public water main, or to a public sewer, is arranged through the water company. The contractor lays the private side.
  • Keep a rough sketch of where the pipe runs once it is in. The next person to dig will thank you for it.
Common questions

Pipe laying: common questions

How deep should a water pipe to a field trough be?
Usually at least 750mm of cover to keep it from freezing, and deeper or protected where vehicles cross it. The contractor will set the depth for your ground.
Do land drains need gravel?
Most do. Gravel over a perforated pipe lets water reach it quickly and stops soil clogging the holes. On heavy clay the gravel may be brought close to the surface so water can get down to it.
Can a pipe be laid without digging a trench?
On open fields a mole plough can pull water pipe in with only a narrow slot left on the surface, which is quick and tidy. It is not suited to stony ground, hard yards or drains that need a precise fall.
Related work

Often booked alongside

All services · Paddock maintenance by county